DIY for Making a Baseball Bat Rack

First-Sand both boards thoroughly using a medium, then fine sandpaper until they are clean and smooth on all sides, and make sure to sand all the edges as well. This is going to give it a very smooth feel.

Next thing, draw a line all the way down the center of one of the boards (line not shown here), then from the edge, make the first mark 2.5" from the edge, then every 3 inches.

Now, check with rural the width of the knob on the bat and pick a hole that was a little smaller than the bat knob and drill the first hole. For a perfect and clean hole on both sides, avoid drilling as soon as the guide bit comes out of the board's other side. Turn the board over and finish the hole on the other side. First, draw the two cut-out lines into which the bat rack can slide. It is a good idea to calculate the ha.

If you've checked your measurements, make a cut and test with a bat.

If it's all right, drill out all the remaining holes (Don't forget to stop halfway and turn the board to finish each hole on the other side!)

Then weigh and mark all remaining parts of the cut-out.

First, use your jigsaw (if you have one) to make the cut-outs for each hole, as seen.

Next, use a rotary tool to carefully smooth out the edges of all holes and cut-out areas as seen on both sides of the board. If you don't have this tool, you can use a stick covered in sandpaper or something else you think you can use. It could take you a little longer, though.

Then, give it one more light sanding to help remove any residual blemishes and pencil marks.

Using the combination square, measure one of the boards' thickness and mark half the thickness where the screws are inserted. Start with the sides, then mark the center, then the remaining two. You're going to end up with even the spacing between the screws.

Next, pre-drill the screw holes on the mainboard with a drill bit a little thinner than the screws you're going to use.

Now, put the other (uncut) board flat in your work area and place the mainboard in position.

Too much to handle one more thing you can do just buy from online or offline there are many businesses out there providing baseball bat rack at very affordable price. All you have to do just search and choose your budget and your requirement.